9V1PL wrote:
Hi Max,
Have you found a solution for this?
I am planning to get a SunSDR2 DX and this is a showstopper since I need to connect to my LDG AT-1000Pro2.
I am currently tuning the LDG using the the ICOM cable from 7300. The 7300 also drives my ACOM 1010 via a single RCA phono cable.
Thinking of moving over to SunSDR but their tuner AAT-100 doesn't support QRO!
Wait let me get this straight, Just where in line is your current TUNER? before or after your 1010
the ATU-100 is only a 100 watt tuner which is WHY it connects directly via the cable to the 2DX- there isn't any reason why you couldn't use the LDG AT-100oPro2 you currently have.
JUMPSTART, OR “REAL HAMS DON’T READ MANUALS!”
Ok, but at least read this one section before operating the AT-1000ProII:
1. Connect a 50-ohm coax jumper cable from the antenna jack on your amplifier to the TX jack on
the back of the AT-1000ProII. (This cable must be rated to 1000 watts.)
2. Connect your antenna’s 50-ohm coax feedline to the ANT 1 jack on the rear of the AT1000ProII.
3. Connect the supplied DC coax cable to the jack marked 12 VDC. Connect this cable to a DC
source between 11 and 16 volts DC, 1000 mA. The jack center tip is positive.
4. Power up the transceiver, and select the desired operating frequency and mode.
5. Bypass the amplifier.
6. Make sure Antenna 1 is selected (ANT 2 LED is off). Press ANT to toggle.
7. Begin transmitting, any mode1
.
8. When the tuning cycle completes, activate the amplifier, and you’re ready to operate!
Note: With the amplifier active, it is suggested to place the AT-1000ProII in semi-automatic
tuning mode to avoid re-tuning at high power levels.
The SAME TYPE of setup you currently running is the SAME WAY you would hook up the 2DX (there is a DB15 connector on the back, you need an AMP cable or Better YET MAKE ONE Pins 13 and Pins 15 of that DB15 connector) are all you need for the 1010 or ANY ACOM TUBE AMP ( solid state can be a bit different and band data control)
In your setup just swap the current 7300 for the 2DX-
I can not understand the over thinking and non understanding basic setup here, It Boggles me there is no show stopper to this its the SAME setup you currently use!