Hello,
I have the following issue with SunSDR2DX.
I am unable to use a microphone and play audio files from N1MM at the same time.
If I use only the microphone, there are no problems. However, if I activate VAC through the SDC program and connect it to N1MM to use
pre-recorded audio files, then in TX mode the microphone input is replaced by TCI and cannot be used.
That is, in SSB mode during transmission, one can use either one of the two options - either the microphone or audio files from N1MM (via TCI-VAC),
but not both simultaneously, which is important for contest operation.
Please share your experience if you have dealt with this problem.

I'm using Eesdr3 with SDC and N1MM on Windows 11, also for VAC i use Virtual audio cable by Muzichenko


Regards Val/LZ2XA