Hello,
I had to study a bit the RigSync manual before doing other tests.
Now I have successfully implemented the schema you can see in the first picture and I can sync logger and other omnirig software using the ComSpider settings you can see in the second picture.
Now I have a problem in keeping in sync the Tentec and ExpertSDR2. I would ExpertSDR2 be my first receiver and Tentec Eagle only the slave transmitter. In the RigsSync tab, in SDC, I am using the serial port for the Eagle and the TCI protocol for ExpertSDR2. This is the best match between the to radios because all other methods are very slow.
The problem is that some sync data work better in one way and not in the other. To be clearer:
FROM TENTEC TO EXPERTSDR2:
- Frequency A/B are OK;
- Mode is OK only for CW. If I set LSB/USB on the Eagle I get DIGL on ExpertSDR2.
FROM EXPERTSDR2 TO TENTEC
- FREQUENCY A/B not OK; if I click on other frequencies in the panadadapter, ESDR goes back to the Eagle Frequency
- MODES are OK
Please, give also a look at my whole configuration to be sure I am going in the right way.
Thank you very much
73' Enzo
iw7dmh