Welcome, Guest
Username: Password: Remember me

TOPIC: Skimmer / Telnet support

Skimmer / Telnet support 25 Nov 2014 16:20 #1

  • AB7R
  • AB7R's Avatar
  • OFFLINE
  • Posts: 55
  • Thank you received: 5
Nice to see the direct CWS support for each panadapter. I did not realize before last night that there was a window display that shows the received spots.

Request....can this the spots received in this window be painted to the panadapter at the correct frequency? There would need to be some duplicate call handling and an expired function.

Can the displayed spots in this window be made clickable so they tune to the correct mode/freq when clicked?

Instead of connecting directly to the CWS telnet port I used the port I set in Wintelnet. This then ports all spots from two CWS instances AND the VE7CC cluster. It sometimes gives an "error in skimmer command" but it still works.

73
Greg
The administrator has disabled public write access.

Skimmer / Telnet support 30 Nov 2014 06:45 #2

  • VassiL
  • VassiL's Avatar
  • OFFLINE
  • Разработчик SDR-техники, Developer of SDR
  • Posts: 1299
  • Thank you received: 248
Yes, ExpertSDR2 software supports direct connection for each independent receiver/panadapter, also software sees the spots from CWS, but it's not show it on the panadapter. We will support it in future releases. At the present time user can use the LOG and show a spots in bandmap or in claster.
Our french customer uses the port mixer and mix the spots, and send it to the cluster in LOG. Tomorrow I will upload a block scheme.

For info: ExpertSDR2 software sends to CWS a center frequency of panadapter and sends all panadapter's spectrum by VAC. CWS calculates frequency for each received signal and send this info with callsign back to telnet.
Василий, Vasily,
Expert Electronics
The administrator has disabled public write access.

Re: Skimmer / Telnet support 30 Nov 2014 07:03 #3

  • AB7R
  • AB7R's Avatar
  • OFFLINE
  • Posts: 55
  • Thank you received: 5
Thanks. I used the setup found on the forum but not seeing any center freq info sent to CWS.
The administrator has disabled public write access.

Re: Skimmer / Telnet support 01 Dec 2014 02:57 #4

  • AB7R
  • AB7R's Avatar
  • OFFLINE
  • Posts: 55
  • Thank you received: 5
I got this working at 192 KHz. I needed to have the CWS option checked to accept skimmer commands.
The administrator has disabled public write access.
Time to create page: 0.060 seconds