Is it possible or planned to be able to get the TCI trough the ERS?
i..e
The tranceiver is connected to a computer running "starter.exe" - i call this the server.
At some other QTH i start the EESDR3 and initiate connection to the tranceiver via the EE cloud. i call this the client
What i want to be able to do is whatever i do on the client im able to see the TCI commands on the server connecting to the WS.
i.e if i on the client change frequency i can on the server see this.
The administrator has disabled public write access.
TCI trough client to server using ERS?
02 Feb 2023 20:31 #2
I have also used TCI with the RF 2K+ amplifier in the ERS setup and all worked well.
I was using VNC and once I put in the Ip for the remote Laptop that I was using everything connected to TCI.
This was using ESDR3 Build 23122022 Version 1.0.2. Beta.
Regards and good luck,
Tom W3FRG
The administrator has disabled public write access.
TCI trough client to server using ERS?
03 Feb 2023 08:46 #4
From the client side TCI works. I can start MSHV and do FT8 QSOs from the client.
But i want to be able to receive/send the TCI on the server side.
See the pictures. ERS_client.png i'm at 7.02MHz, then i can use VNC to check on the server side and issue the vfo command and then i should get the same frequency but i get 14.105Mhz.
Been able to get the TCI from the "starter.exe" on the server side i can use and control other tools on the computer where the tranceiver is located.