Welcome, Guest
Username: Password: Remember me

TOPIC: EESDR2 modes not indicated correctly

EESDR2 modes not indicated correctly 27 Nov 2021 15:41 #1

  • danielwee
  • danielwee's Avatar
  • OFFLINE
  • Posts: 209
  • Thank you received: 29
EESDR2 1.3.1 update 11

EESDR2 can get confused about the current mode when TCI is being used to change mode at the same time you are manually changing modes. To reproduce:-

1. Start EESDR2 with TCI enabled
2. Start JTDX in TCI mode and have it decoding on a band
3. On JTDX make sure to select the band from the drop down menu
4. EESDR2 should not conform to the frequency and mode selected in JTDX
5. While JTDX is still decoding on the band, manually tune to another part of the band where there is no FT8 signals (say the CW portion)
6. Manually change the DIGIU or USB that JTDX was using in EESDR2 to CW
7. You will hear the mode change for a second before JTDX changes the mode back to what it wants
8. Now EESDR2 shows CW mode but is in fact in either DIGIU or USB
9. To properly get CW, shut JTDX down and then click CW again
The administrator has disabled public write access.
Time to create page: 0.097 seconds