Welcome, Guest
Username: Password: Remember me

TOPIC: EESDR V3 Tune function does not work with Acom 1000

EESDR V3 Tune function does not work with Acom 1000 26 Jan 2022 22:56 #1

  • EI3IBB
  • EI3IBB's Avatar
  • OFFLINE
  • Posts: 26
  • Thank you received: 1
Tune function on V3 11 doesn't work, for some reason it won't switch the Acom 1000 but yet TX on SSB works fine, V2 tune works so I use that to tune the amp. Any ideas ?
The administrator has disabled public write access.

EESDR V3 Tune function does not work with Acom 1000 26 Jan 2022 23:48 #2

  • danielwee
  • danielwee's Avatar
  • OFFLINE
  • Posts: 209
  • Thank you received: 29
Is the Tune output power level set correctly?
The administrator has disabled public write access.

EESDR V3 Tune function does not work with Acom 1000 29 Jan 2022 18:24 #3

  • EI3IBB
  • EI3IBB's Avatar
  • OFFLINE
  • Posts: 26
  • Thank you received: 1
Yes no matter what it's set to the amp doesn't seem to be getting the signal to activate.
Last Edit: 29 Jan 2022 18:25 by EI3IBB.
The administrator has disabled public write access.

EESDR V3 Tune function does not work with Acom 1000 30 Jan 2022 06:39 #4

  • danielwee
  • danielwee's Avatar
  • OFFLINE
  • Posts: 209
  • Thank you received: 29
Are you able to just test the output from the radio into a dummy load (with an external power meter) just to make sure that the radio is putting out power? I use EESDR3 with SunSDR2DX and Tune appears to be working for me.
Last Edit: 30 Jan 2022 06:40 by danielwee.
The administrator has disabled public write access.

EESDR V3 Tune function does not work with Acom 1000 30 Jan 2022 08:48 #5

  • DF2LH
  • DF2LH's Avatar
  • OFFLINE
  • Posts: 15
  • Thank you received: 3
HI
I am not at the radio now. I remember there is a switch in the radio setup 'Use PA in Tune'. It's were you set the radio IP Adress. Please have a look
vy 73 Thomas
The administrator has disabled public write access.

EESDR V3 Tune function does not work with Acom 1000 30 Jan 2022 11:56 #6

  • danielwee
  • danielwee's Avatar
  • OFFLINE
  • Posts: 209
  • Thank you received: 29
Oh yes - that is correct. If you don't check that, the TUNE will not assert the PTT for the amplifier. That's most likely the issue it seems.
Attachments:
Last Edit: 30 Jan 2022 11:57 by danielwee.
The administrator has disabled public write access.

EESDR V3 Tune function does not work with Acom 1000 30 Jan 2022 16:04 #7

  • EI3IBB
  • EI3IBB's Avatar
  • OFFLINE
  • Posts: 26
  • Thank you received: 1
Thanks for the help, works now :-)
The administrator has disabled public write access.
Time to create page: 0.082 seconds