Welcome, Guest
Username: Password: Remember me

TOPIC: ExpertSDR 3 0.12 alpha TCI audio problem

ExpertSDR 3 0.12 alpha TCI audio problem 01 Mar 2022 14:27 #1

  • DK8JV
  • DK8JV's Avatar
  • OFFLINE
  • Posts: 23
  • Thank you received: 6
Dear EE team,
Thank you very much for this new alpha version. I'm really amazed that now, all the audio glitches seem to have gone.
However, I'm facing a little problem. Could it be that the "TCI" transmit parameter is no longer regarded in TCI 1.8?
I have programmed a TCI <-> VAC / CAT bridge to link EESDR3 to RemoteHams which ran fine with ver. 0.11.0. However, in ver. 0.12.0, TCI 1.8, when I issue the
"trx:0,true,TCI;" command, the software does not switch to TCI audio stream. When transmitting it stays on "Mic.2" instead of changing to using the TCI stream.

Besides that, everything is looking fine. Thank you very much!

vy 73
Eberhard, DK8JV
P.S.: No time to check this in detail right now. Will do as soon as I find some spare time. I guess that SDC might also be affected. (when using VAC in SDC)
The administrator has disabled public write access.

ExpertSDR 3 0.12 alpha TCI audio problem 01 Mar 2022 14:43 #2

  • DK8JV
  • DK8JV's Avatar
  • OFFLINE
  • Posts: 23
  • Thank you received: 6
Sorry for the trouble - looks like I found the cause of the problem.
While in TCI 1.7, the TCI parameter for the trx command was accepted in capital letters it now needs to be issued in small letters. "trx:0,true,tci;" works, "trx:0,true,TCI;" does not.

Best 73
Eberhard
The administrator has disabled public write access.
Time to create page: 0.076 seconds