Welcome, Guest
Username: Password: Remember me
*****PLEASE, CHECK ALL PREVIOUS TOPICS, BEFORE CREATING A NEW ONE! DUPLICATED TOPICS WILL BE DELETED!*****

TOPIC: Hot switching on Acom 600s

Hot switching on Acom 600s 13 Nov 2020 21:44 #1

  • w1fq
  • w1fq's Avatar
  • OFFLINE
  • Posts: 17
Should raising the time delays on the DEVICE/PA panel allow the MB-1 to key the amp, ACOM 600s?

I am getting a HOT SWITCHING msg on the amp.

I do not have this problem with an older Tokyo Hy-power amp.

Thanks,

Thorny
W1FQ
The administrator has disabled public write access.

Hot switching on Acom 600s 14 Nov 2020 07:22 #2

  • g0cgl
  • g0cgl's Avatar
  • OFFLINE
  • Erik EI4KF / G0CGL
  • Posts: 1192
  • Thank you received: 474
Is that on all modes? I have 20ms delay set for RX>TX and 5ms TX>RX in that panel but EE state that these are disabled in CW. So for that mode I use the Break-In delay parameter.
Last Edit: 14 Nov 2020 07:23 by g0cgl.
The administrator has disabled public write access.

Hot switching on Acom 600s 14 Nov 2020 10:21 #3

  • w1fq
  • w1fq's Avatar
  • OFFLINE
  • Posts: 17
Thank you.

Yes, it wks on SSB, I'll check the Break-in.

I saw the announcement, but as it worked on my other amps was confused.

TKS
The administrator has disabled public write access.

Hot switching on Acom 600s 14 Nov 2020 10:34 #4

  • w1fq
  • w1fq's Avatar
  • OFFLINE
  • Posts: 17
That did it, thanks
The administrator has disabled public write access.
Time to create page: 0.148 seconds