Welcome, Guest
Username: Password: Remember me
*****PLEASE, CHECK ALL PREVIOUS TOPICS, BEFORE CREATING A NEW ONE! DUPLICATED TOPICS WILL BE DELETED!*****

TOPIC: Power output

Power output 10 Nov 2018 19:10 #1

  • ve3wdm
  • ve3wdm's Avatar
  • OFFLINE
  • Posts: 58
  • Thank you received: 4
I was re-installing some software and wanted to just check to make sure it was talking to the Expert SDR software. All communicated just fine with the software BUT I did notice that my SWR was "wonky" when connected to A2. What I mean by wonky is the SWR would shoot up to 11.1 then the rig was moved. After some trouble shooting I found that moving around the female SMA connector on the SunSDR2 Pro rig the SWR would shoot up very high. I swapped the SMA/SO239 jumper to the A3 connector and all was good no matter how much the SMA female on the rig and the SMA/SO239 jumper was moved around. I'm hoping there is no issue with the rigs connector as the rig is basically brand new? Has anyone had this issue? Just to ask Rome the same question...........have you had this show up on other SunSDR2 pro's ? At this point I am just using the A3 connector.
Any ideas?
Mike
VE3WDM
The administrator has disabled public write access.
Time to create page: 0.117 seconds