Welcome, Guest
Username: Password: Remember me

TOPIC: Audio Levels when using SDC/TCI

Audio Levels when using SDC/TCI 22 May 2022 11:02 #1

I have been told by amateur that my transmitted signal is wider than it should be, on 6m, when using FT8 he sent me a screen grab which does appear to show some whiskers on each side of my signal. He does have the perfect QTH, does have a nice antenna and he looks down on top of me from the other side of the river when beaming south towards Europe, which we do most of time. At the moment I am running EESDR2 1.3.1update 11 with SDC64 utilising TCI. I use JTDX for FT modes. As far as I can see, I have all audio controls set at minimum from Windows 10 downwards. Is there any control over audio within TCI. I have only discussed this over 6m and not on the HF bands. so I dont know if it is peculiar to 6m only. My Amp is an ACOM1000. I normally run around 200 watts when looking for DX, so my SDR2 DX is just loafing along as is the amplifier. What to do? You can see my mic level is set at 0,5dB and nothing I change seems to alter this fixed level.
The administrator has disabled public write access.

Audio Levels when using SDC/TCI 22 May 2022 11:04 #2

I tried to include a screen shot but it doesnt appear to have come out??
screenshot6m.jpg
The administrator has disabled public write access.
Time to create page: 0.074 seconds