Welcome, Guest
Username: Password: Remember me
*****PLEASE, CHECK ALL PREVIOUS TOPICS, BEFORE CREATING A NEW ONE! DUPLICATED TOPICS WILL BE DELETED!*****

TOPIC: TCI native support of the RF-KIT PA

TCI native support of the RF-KIT PA 31 Jul 2021 00:26 #1

  • hb9bun
  • hb9bun's Avatar
  • OFFLINE
  • Posts: 8
  • Thank you received: 2
:stars: No issue, just as information. With the newest firmware G91C109 the RF-Kit PA now has native support for TCI. I just upgraded and am enthusiastic. I already liked the UDP support, but now with the direct TCI connection the TX frequecy is available immediate, fast and reliably (and wireless anyway).
And there is much more potential to it in the communication PA with EESDR. .
Thank you SunSDR, RF-Kit team and Yuri, UT4LW, for getting it there for us.
73, Peter - HB9BUN
Last Edit: 31 Jul 2021 00:27 by hb9bun.
The administrator has disabled public write access.

TCI native support of the RF-KIT PA 25 Dec 2021 10:42 #2

Hello all, Peter,

TCI doesn't seem to work here.
Is it correct to use the ip adress of my sunsdr dx in the box "HOST" ?


73 Gert ON4GPE
The administrator has disabled public write access.

TCI native support of the RF-KIT PA 27 Dec 2021 13:12 #3

  • hb9bun
  • hb9bun's Avatar
  • OFFLINE
  • Posts: 8
  • Thank you received: 2
Hello Gert,
no, you need to put the IP of the computer EESDR is running on.
73, Peter
The administrator has disabled public write access.

TCI native support of the RF-KIT PA 27 Dec 2021 13:47 #4

  • DF2LH
  • DF2LH's Avatar
  • OFFLINE
  • Posts: 15
  • Thank you received: 3
Hello : )

I have tried to connect my RF2K-S via SDC. Unsuccessful so far. The IP of the PC with ExpertSDR2 and SDC is entered in the PA. I have entered a port other than the one for ExpertSDR TCI to SDC. In SDC IP from my RF2K-S with the choosen port.

Are there any examples or instructions for this case?

EDIT:
I have just connected the PA directly to EESDR2 via port 40001. It works immediately. I'm afraid I didn't understand the point of PA control via SDC. Unfortunately, this is not described for the RF2K-S in the SDC manual. it seems to be intended only for a CAT port. I was hoping for PTT via TCI.

73 Thomas, DF2LH
Last Edit: 27 Dec 2021 14:14 by DF2LH.
The administrator has disabled public write access.

TCI native support of the RF-KIT PA 27 Dec 2021 14:08 #5

Thanks Peter, i used the ip of the trx. Works fine now !

73 HNY
The administrator has disabled public write access.
Time to create page: 0.111 seconds