I installed LogHX yesterday and it is working just fine.
Currently radio 1 which is VFO A is on 40 meters. The MB1 is communicating with the software using TCI.
I currently have VFO B on 80 meters.
I tried to setup this in LogHX as radio 2, also using TCI.
But it seems the software is not communicating with the MB1 with that particular setting.
Does anyone know of a way that I can do that?
I did read on a flexradio board that Omnirig was used where he could access both slices or VFO's.
Any help would be much appreciated.
Mark Griffin, KB3Z
The administrator has disabled public write access.