Welcome, Guest
Username: Password: Remember me
*****PLEASE, CHECK ALL PREVIOUS TOPICS, BEFORE CREATING A NEW ONE! DUPLICATED TOPICS WILL BE DELETED!*****
  • Page:
  • 1
  • 2

TOPIC: MB1 SDR2 software not executing

MB1 SDR2 software not executing 04 Jan 2020 19:03 #16

  • KB3Z
  • KB3Z's Avatar
  • OFFLINE
  • Posts: 203
  • Thank you received: 2
I see that if I go into LogHX and uncheck the frequency ranges in the Band mode under General Setup, it goes back to EESDR Mode Control.
Currently using TCI for the rig control. Not sure if I went to com ports whether that would effect the band mode control or not.
Mark KB3Z
The administrator has disabled public write access.

MB1 SDR2 software not executing 07 Jan 2020 12:27 #17

  • KB3Z
  • KB3Z's Avatar
  • OFFLINE
  • Posts: 203
  • Thank you received: 2
I have switched back to version 1.2.
One problem I did have is when I started EESDR2 the VHF LNA was lit on the screen.
When I pushed the red start button, it did go off.
Why that was happening is beyond me.
I guess if there was any additions I would like to see in a new version is better receive sensitivity and perhaps filtering.
I have not looked at the new noise blanker.
I know there is a video out on this, so will have to review it at some point in time.
Mark Griffin, KB3Z
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 0.124 seconds