Thank you for your reply. Last night I installed the VSPE software from Eterlogic. They graciously offer for you to try their software before you buy it, so I am running it as "unregistered" at the moment. I've completed all of the setup and settings. I've made sure to start the VSPE application and load the config settings before opening the ESDR2 application. After ESDR2 is running I open N3FJP. Unfortunately, N3FJP is not communicating with ESDR2. N3FJP is trying to poll the MB1 through virtual Com Port 6, but it is not finding it. Perhaps when I Register the Eterlogic software this will fix it? I'll try that tonight.
Here are some screen captures. Unfortunately, I failed to grab the screen capture from N3FJP CW Setup where I set the CW Com Port, but I did do that also.