Welcome, Guest
Username: Password: Remember me

TOPIC: AAT-100 Memory

AAT-100 Memory 25 Dec 2021 08:56 #1

  • ON3CQ
  • ON3CQ's Avatar
  • OFFLINE
  • Posts: 26
  • Thank you received: 5
Hello,
I'm using the AAT-100 on the SunSDR2 DX here.
My station is running 24/24 only when I stop I close the software the SunSDR2 DX continues run.
Every time the software starts up again V2 or V3 0.11 I have to re-tune the antenna on a certain band where I use AAT-100.
The SunSDR2 DX continuous 13.8v why the data is not remembered AAT-100.

Merry Christmas 73 - Pat
The administrator has disabled public write access.

AAT-100 Memory 25 Dec 2021 10:12 #2

  • danielwee
  • danielwee's Avatar
  • OFFLINE
  • Posts: 209
  • Thank you received: 29
From what I remember, my AAT-100 does recall the settings per EESDR installation. You should be able to see the settings in the saved .ini (for EESDR2) file to verify.
The administrator has disabled public write access.

AAT-100 Memory 25 Dec 2021 14:19 #3

  • ON3CQ
  • ON3CQ's Avatar
  • OFFLINE
  • Posts: 26
  • Thank you received: 5
I can't find this file.
Schermafbeelding2021-12-25151801.png
The administrator has disabled public write access.

AAT-100 Memory 25 Dec 2021 16:26 #4

  • danielwee
  • danielwee's Avatar
  • OFFLINE
  • Posts: 209
  • Thank you received: 29
I believe it is kept inside the atu_base_dx.ini file. There is a whole section dedicated to the settings for the ATU. I'm not sure if some settings are kept in the options.ini file also. In any case, I think you should see the atu_base_dx file change when you have new tuning settings get saved.
The administrator has disabled public write access.

AAT-100 Memory 25 Dec 2021 17:52 #5

  • ON3CQ
  • ON3CQ's Avatar
  • OFFLINE
  • Posts: 26
  • Thank you received: 5
I find the file.
Attachments:
The administrator has disabled public write access.
Time to create page: 0.082 seconds