Is it possible or planned to be able to get the TCI trough the ERS?

i..e
The tranceiver is connected to a computer running "starter.exe" - i call this the server.

At some other QTH i start the EESDR3 and initiate connection to the tranceiver via the EE cloud. i call this the client

What i want to be able to do is whatever i do on the client im able to see the TCI commands on the server connecting to the WS.
i.e if i on the client change frequency i can on the server see this.

Hello

TCI work with client ExpertSDR3 connected remotely by ERS
i used JTDX and Loghx at the remote client EE3 Beta 1.02

Almost everything work well
I have done hundreds of FT8 QSOs with no problem.

You can look on github for the details about the bugs that remain

73 Joseph

I have also used TCI with the RF 2K+ amplifier in the ERS setup and all worked well.
I was using VNC and once I put in the Ip for the remote Laptop that I was using everything connected to TCI.
This was using ESDR3 Build 23122022 Version 1.0.2. Beta.

Regards and good luck,
Tom W3FRG

From the client side TCI works. I can start MSHV and do FT8 QSOs from the client.

But i want to be able to receive/send the TCI on the server side.

See the pictures. ERS_client.png i'm at 7.02MHz, then i can use VNC to check on the server side and issue the vfo command and then i should get the same frequency but i get 14.105Mhz.

Been able to get the TCI from the "starter.exe" on the server side i can use and control other tools on the computer where the tranceiver is located.