Hi all, had a problem with cw keying via comport and n1mm connected to cat,
when sending a series of dots sometimes there was a crack and a little gap in the dots when n1mm is not connected keying is good.
reducing the speed of cat to 4800 db and radio polling delay 100% in n1mm it all works ok.
the cat control is still fast enough ,
Any one had simmilar problems or a different solution ???
(During contest this messed up my cw sometimes when i had to use the paddle)
(with crack i mean you hear a cracling sound in side tone.)
Последнее редактирование: 31 Окт 2016 06:47 от pa5fn. Причина: type error
Tnx for the new beta Vassily ,well i still have to lower the radio polling in n1mm to 100% lower for sending cw via comport without artifacts, i raised the speed to 115200bd ,then the cw is still good.
the cat control works fast enoug,
with normal radio polling rate you still get a occasional gap in the caracters and you hear a crackling noise
one other thing the 60 meter band is abt 15 KC, here in holland we may use 100Kc for the moment, by setting the regio to 1
in the regioconfig file i can use the whole band.
Hi Vasily, well after a lot of tests i had to reduce the speed to 4800 bd,and slowest radio polling, then it works perfect,
further, i use the comport for the paddle, cwtype is on additional key for memory keyer, n1mm keys with the cat control
with higher speeds for cat control i get occasional hicups.
i am new of the forum and newcomer of the Expert family!
I have a problem setting N1MM CW macros (and also in Qartest, same problem). When I push the cq macro, the tx starts correctly but after 2 or 3 letters starts to loose dots and dashes and it seems totally random. I followed the MB1 user addendum to set all COMs. CAT work perfectly but CW not.
Could you help me to sove the problem?