Hi board , thanks to all .
Unfortunately i leave this project also because 1000 Mp CAT is very slow and i'm not able to manage one vertical antenna and one magnetic loop Wellbrook with SDR
I come back to my SunSDr2 Pro .
I wanted to macth an old trx with 200 watts and an Colibri SDR

ELKING пишет:
Hi, Rome here is 2 video clip same setup same settings IC7300+PTRX7300+ColibriNANO

Video 1 update 8 ADC OK
drive.google.com/file/d/1Vqj2u_5yOJZpTdJkfAuPKx5PyseUdIl-/view?usp=sharing

Video2 update 10 ADC NG red alert overload ADC
drive.google.com/file/d/1Iku4c7VyNXZHVDQsIaT4cmOgy0uei9hS/view?usp=sharing

Ciao Helking , i'm just thinking on your issue .
When you use if-out with PTRX7300 are there signal when you transmit ?
Why we see overload on Colibri ?

73, SANDRO

Alex65 пишет:
Hi Sandro

Something is wrong with update 10 expert sdr2 software with update 8 expert sdr2 is everything ok.
I have been using such a combination for a long time and over several versions of expert sdr and until update 10 I never had a problem with red alert on RX and TX.
With update 10 there is a problem with overloading the ADC on the RX as well as in my combination on the TX
My setup PTRX7300 is RX out no IF with no limit on bandwidth all HF I can listen to 80m on the IC7300 but at the same time, I am with expert sdr on the 20m band
Of course, when I go to Tx there is muting on this other band.
br Elvis

Hi Helking
But is better to hear SDR colibri or Icom 7300 ?
Ciao

Hi Sandro

Both are great it’s all a matter of taste
regards Elvis

"Rome' wrote : Hi, Sandro.
Please try to use SDC as a hub, connect it to ESDR2 via TCI and your Yaesu ft 1000Mp via CAT (or OmniRig if CAT is unavailable)".

Hi Rome sorry for delay that i reply .
Do you have some sample to follow?
Is not simple to understand SDC .

73, sandro

Can you tell me how to use the RX mute with a Yaesu Transceiver connecting it to RX out? Can seem to figure it out. Audio never shuts off when transmitting.

OmniRig > EESDR ver 2 update 8 > Options > CAT > put data from Omnirig Rig1 > Enable CAT
When Transceiver is connected via the CAT protocol when the trx goes to the transmit , the mute in the Expert SDR2 ColibriNANO is automatically switched on.

Might be the OmniRig setting for DTR/RTS relating to PTT? I've set mine to LOW for both DTR and RTS in OmniRig.