This is a test version of the software ExpertSDR2 for MB1.
Link: ExpertSDR2 1.1.3 RC5 MB1
The information about new functions and fixes from RC4(was not published) and RC5 versions.
Main changes:
RIT/XIT bug fixes
Bug fixed in the CAT system, which can freeze ExpertSDR2 software
Into CAT system was added global volume control
Bug fixed of Split/SubRX settings
Now if you press to Voice Play button by left mouse button, the software will switch TRX to TX mode and will play record. By right mouse button - only play record without TX mode.
Was improved waterfall, now you can see fast signals on the waterfall
If you cahge band, SubRX and Split will be switched off
Added RX ANT button
Added presets of audio mixer for RX1/RX2 switching to E-Coder panel functions
Added RX1/RX2 switching control to E-Coder panel with auto audio mute in other RX.
Fixed bug in VOX. When the radio in TX mode and the VOX function switched off, the radio stayed in TX. Now after swithing VOX function radio goes to RX.
MB1:
Improved equalizer in RX and TX modes
Improved CW keying via COM-ports
Fixed bug with PA switch(always worked in TUNE mode)
Improved SWR protection function
Fixed bug in PWR and T.PWR functions
TxB button now works on the front panel. It switches on/off SubRX and SPLIT at the same time.
Fixed bug in the NB function. When threshold was less then 1.17 the software freezed
Fixed High SWR indicator bug in the MB1 GUI
Fixed ATU bug. Now if ATU can not match impedance, the radio goes to RX mode.
Added User filter indication
The protocol between SDR board and PC was optimised
Into the Desktop GUI was added audio buttons PC/SDR/Speaker
Bug fixed. When you long pressed to PLAY button on the front panel - it was not played. Now it's played.
Improved VOX
Bug fixed. Power correction coefficients now works correctly
Bug fixed in CW (if you press write button CW settings stayed in reset)
How the RX ANT button works:
The RX ANT button switches on the antenna port with RX antenna, which was chosed in the menu. You can not set antenna port as RX ONLY if this port is used for TX mode.
The audio mixer presets description:
If you uses two independent receivers RX1 and RX2 in SO2R mode or in other applications and you want to listen only RX1, or only RX2, or both receiver but in the different channels(left/right), you can use new functions. You can set these functions in the E-Coder panel.
1. Both RXes with the same audio level in left and right channels;
2. Listen only RX1;
3. Listen only RX2;
4. Listen RX1 in left channel, and RX2 in right channel;
5. Listen RX1 in right channel, and RX2 in left channel;