Добро пожаловать, Гость
Логин: Пароль: Запомнить меня
*****PLEASE, CHECK ALL PREVIOUS TOPICS, BEFORE CREATING A NEW ONE! DUPLICATED TOPICS WILL BE DELETED!*****

ТЕМА: N1MM CW Keying with MB1 Issue

N1MM CW Keying with MB1 Issue 29 Дек 2018 20:48 #1

  • KB3Z
  • KB3Z аватар
  • Вне сайта
  • Сообщений: 264
  • Спасибо получено: 5
Good Afternoon,
I am having a real problem getting N1MM to key my MB1 for CW.
It works just fine with a paddle but no go when it comes to software generated CW.
I have the vcom set up within ESDR where I have com 5 setup for computer syncing and com port 9 for transmit.
So when I get into N1MM I then have com port 6 to communicate with the MB1 which it does. But, if I have com port 10 set for cw, I can't get the MB1 to go to transmit.
I have tried to follow Erik's instructions, but for some reason I have either missed something or setup something incorrectly.
Has anyone out there done this and gotten it to work?
Please help!
Mark Griffin, KB3Z
Администратор запретил публиковать записи гостям.

N1MM CW Keying with MB1 Issue 29 Дек 2018 21:16 #2

  • g0cgl
  • g0cgl аватар
  • Сейчас на сайте
  • Erik EI4KF / G0CGL
  • Сообщений: 886
  • Спасибо получено: 352
Re-check that you have followed the UMA addendum, especially pages 30 and 31. You should have created COM 11 in VSPE and be using this in ESDR2 and N1MM+, not COM 10 as you have because that is half of the pair for PTT.

Erik.
Администратор запретил публиковать записи гостям.

N1MM CW Keying with MB1 Issue 30 Дек 2018 00:02 #3

  • KB3Z
  • KB3Z аватар
  • Вне сайта
  • Сообщений: 264
  • Спасибо получено: 5
Erik,
I changed it to COM 11
I set DTR to CW and RTS to PTT.
I PTT Delay 20. It was 0
I push f4 and it does nothing.
I am at a loss on what to do.
Администратор запретил публиковать записи гостям.

N1MM CW Keying with MB1 Issue 30 Дек 2018 00:14 #4

  • KB3Z
  • KB3Z аватар
  • Вне сайта
  • Сообщений: 264
  • Спасибо получено: 5
Erik,
I got it. I went into the options and added the Secondary Key for COM Port 11.
It now works.
Yes, I need to take my time and read the directions.
Thanks!!!
Mark KB3Z
Администратор запретил публиковать записи гостям.
Время создания страницы: 0.117 секунд