Добро пожаловать, Гость
Логин: Пароль: Запомнить меня

ТЕМА: Enable Transmit Analyzer for Receiver

Enable Transmit Analyzer for Receiver 01 Сен 2020 11:35 #1

  • W2PH
  • W2PH аватар
  • Вне сайта
  • Сообщений: 17
It would be really nice to be able to use the transmit Analyzer in the receive mode to allow us to analyze stations on the air to see where their audio spectrum lies. I realize it will take a strong signal to make it usable. Thanks Ed W2PH
Администратор запретил публиковать записи гостям.

Enable Transmit Analyzer for Receiver 01 Сен 2020 20:15 #2

  • G4ENZ
  • G4ENZ аватар
  • Вне сайта
  • Сообщений: 10
  • Спасибо получено: 4
SDC Software Defined Connectors has an Audio scope tool that you might find does the job for you.

73 Martin
G4ENZ
Администратор запретил публиковать записи гостям.

Enable Transmit Analyzer for Receiver 02 Сен 2020 16:55 #3

  • N8SDR
  • N8SDR аватар
  • Вне сайта
  • Сообщений: 37
  • Спасибо получено: 16
If you expand (you'll most likely need to increase your spectrum display) you can get a really good amount of information on where's ones audio lies and also there Tx bandwidth and IMD products, it takes time to get and comprehend but after sometime you begin to recognize most of what you are asking from looking at the panadater in an expanded view-
73 Rick
Последнее редактирование: 02 Сен 2020 16:56 от N8SDR.
Администратор запретил публиковать записи гостям.

Enable Transmit Analyzer for Receiver 18 Окт 2020 18:54 #4

  • W2PH
  • W2PH аватар
  • Вне сайта
  • Сообщений: 17
Thanks for the above replies, I would prefer it to be able to use the well designed Tx display shown with the drop down arrow next to "PROC" by enabling "Show Analyzer. It has audio frequencies already labeled and would be an excellent way to analyze received signals for audio waveform. Expanding the IF display doesn't provide audio frequency markers.
Thanks
Администратор запретил публиковать записи гостям.
Время создания страницы: 0.122 секунд