Hello,
I am using the ExpertSDR2 software and I want to install a noise phase canceller between the RX OUT and ADC IN connections to always be active. With this unit installed, I also want to switch between antennas connected to the A2 and A3 antenna connectors using the RX ANT button - with either input signal passing through the connected noise phase canceller. This is for HF only. I am using an EFHW (RX/TX) antenna connected to A2 and an RX-only magnetic loop antenna connected to A3.
From the SunSDR2-DX's block diagram, it seems this should be possible, but the ExpertSDR2 software won't allow it. In order to enable the ADC IN, I have to select ADC IN as an antenna (in the ANT menu) which causes the RX ANT button to only switch between ADC IN and A3. Would it be possible to separate the enabling of the RX OUT / ADC IN external receive signal path from the A2/A3 antenna input selection? Is this functionality available in ExpertSDR3 software?
Thank you.