Добро пожаловать, Гость
Логин: Пароль: Запомнить меня
*****PLEASE, CHECK ALL PREVIOUS TOPICS, BEFORE CREATING A NEW ONE! DUPLICATED TOPICS WILL BE DELETED!*****

ТЕМА: Transverter. Ctrl Pins

Transverter. Ctrl Pins 13 Июнь 2020 12:17 #1

  • IK4ADE
  • IK4ADE аватар
  • Вне сайта
  • Сообщений: 2
I have 10 GHz kunhe transverter with input 1 watt at 144MHz.
So I use 2 m side and in the panel control I have puted 2,5.
For relais in the transverter for ptt commutation is ok in ctrl Pina 13 and 15 ( as a linear amplifier) or is there better?
TNX 73 Franco
Администратор запретил публиковать записи гостям.

Transverter. Ctrl Pins 15 Июнь 2020 14:44 #2

  • IK4ADE
  • IK4ADE аватар
  • Вне сайта
  • Сообщений: 2
With commutation at pins 13 and 15 (as a linear amplifier) I risk to demage the transverter if I don't remember to click PA in the screen.
Anyone know other system to comutation tx-rx for transverter?
Администратор запретил публиковать записи гостям.

Transverter. Ctrl Pins 15 Июнь 2020 15:10 #3

  • g0cgl
  • g0cgl аватар
  • Сейчас на сайте
  • Erik EI4KF / G0CGL
  • Сообщений: 923
  • Спасибо получено: 376
There is one fool-proof PTT method and that uses SDC. You do not need anything special. It allows many PTT actions for various devices that need it. It cannot fail because it emulates a COM port action, either CAT or PTT, driven by TCI from the transceiver. If the radio is going into TX, the PTT must activate.

You need a USB COM port adapter with FTDI driver, a two-wire cable (ground and either the DTR or RTS pin) to the plug for the transverter PTT input (usually RCA), and you need SDC version 12.20 or later.


ptt.png



On the TCI tab, initiate Rig Emulator, set it for PTT and assign it the COM port number created by the USB COM and configure the port as required.
Последнее редактирование: 15 Июнь 2020 15:16 от g0cgl.
Администратор запретил публиковать записи гостям.
Время создания страницы: 0.135 секунд