I need to use VAC cables to link to MSHV so that I can use FSK441 mode (TCI will not work in FSK441). I can get the RX audio to work using RigSync and VAC...but not Tx audio. Has anyone got it working or does it look like a bug? I'm sure I had it working some time ago but ESDR3 has been issued a few times since.
Regards
Paul M0CVX

I tested this and it seems to work.

Using ubuntu.

In RadioSync i set up Sound Card TX/RX for whatever interface you have.

But to get any modulated RF i had to choose "Microphone PC" in EESDR3 config.

Thanks for your reply. I'm pretty sure that I tried that, and it didn't make any difference...but I'll try again tomorrow.
Regards
Paul

If you still have issues i can try again as all i did now was to listen on my ft817 if i got any modulation from MSHV.

But as this is only audio i guess it should be possible for the MSHV developer to add all the MSHV modes for TCI if we request this :-)
I think its "only" resampling of the audio that is required but this is a field i don't really know...

My curiosity got the better of me, so I went out to the shack and tried again...
You're right, it does work. Selecting PC Mic is necessary in the Mic selection setting, and also the VAC line in the soundcard drop-down on the footer of ESDR3. I'm no novice to ESDR3 but I forgot to do all the necessary steps. Thank goodness an ESDR3 manual is being released soon ....it is long overdue!
Thanks for your steer...it did the trick.
Regards
Paul M0CVX