To those of you who have interest in outboard audio gear and running 3Plus K of TX or Rx audio bandwidth:
Many of use eSSB guys use rack equipment to setup up or TX audio chains for producing beyond 3 K TX audio , typically 4K-8K depending on conditions and parts of the band
I recently came across a product which has been around for a few years, but found it works extremely well for producing some very nice audio
It is the X-Air series mixes made by Behringer, however unlike multiple pieces of rack gear all the cabling which can lead to RF issues
The unit I am using is the XR12 t is a 12 channel mixer but also contains basically a built in DAW- since the entire unit is outboard and the interface is GUI based the latency is Very Low.
Its a simple setup requiring just a few connections Mic to one f the input channels and cable from output to the Mic connector on the rig
my X-Air profile contains a Mic pre amp- a Parametric EQ a Gate and compressor on the input channel
in the FX modules I use a sound maxer, some plated reverb- then pass that along to another compressor and a notch via another parametric EQ out to bus1 and into the rig
The box is full of effects (google x-Air effects) the Xr12- to there x32 all contain the same GUI and interfaces
www.behringer.com/product.html?modelCode=P0BI6
[url=http://]www.behringer.com/product.html?modelCode=P0BI6[/url]
I have coined this unit rack in a Box
for a single piece of gear it an cover multiple rack gear at a much less cost and it works extremely well, has been RF proof this afar as well even sitting only inches from the Acom1000
Compressors- Multiple EQ - D-ESSRs- Multiband compressors- revers and plating- and Much More-
If you have interest or would like more info let me know-