Hi All,
I, have an SDR2dx using version 2 software on a Win10 PC
I am new to this software, although I have used PowerSDR in the past.
Question.......can you expand the frequency coverage of the spectrum display as you can ,in say, PowerSDR?

Regards Roger G0IUW

Roger-G0IUW

Look on the main display in the lower left corner. This is the Sample rate selection.
You will see a Frequency there in KHZ, Click on it.
A list will pop up with 4 frequencies ranging from 39Khz to 312Khz.
Click on the bandwidth needed.
I believe this is what your requesting info for?

GL Tom W3FRG

Tom,
Thanks but I dont see thaton my display...bottom left is CPU useage etc

Regards Roger G0IUW

If you are using ver 2 SW go to Options ... You will see sample rate there on the left side.... Use 39062.5, 78125, ....

Roger
Sorry about that. You are correct, I was using SDR3 eesdr not SDR2 as your using.
Attached is a picture showing where the BW is located.
Hope this helps.
When will you be going to EESdr3?
Somewhat easier to locate items used.

GL Tom W3FRG

Gentlemen..
Thank you both for the help...It is now sorted.

Tom.... I,m thinking about V3 but its taken me some time to get V2 running that I,m a bit scared to change it. (i,m not the most computer literate guy ! )

73 de Roger G0IUW

Tom W3FRG пишет:
What about reading the first Rogers post carefully? You are native english (american) speaker ... I am not....