N8SDR wrote:
could you not use the accessories (DB15 connector) on the back- I do not recall but I think pins 13 and 15 you could then use them to energize a relay to ground antenna when you are in TX mode.
pins 13 and 15 are used when you need to trigger an amp to go to TX- you would need to turn on PA mode in the EESDR software but if those pins trigger an external amp you could easily build a relay to ground antenna when tx is applied
Yes, that's right.
Anyway you should consider adding a delay between the PTT-ON and the actual start of transmission. In SSB you can set the "PTT switching delay" values in the "Options->Device->TX" panel. In CW it is a bit more complicated because such delays don't work. You can only set the "BreakIn->Macros Delay" value, but for live CW manipulation you should use a external cw keyer with separate key-ptt outputs.
73' Enzo
iw7dmh