Hi,
I have a question.
I have setup ExpertSDR3 with a SunSDR DX2 with 'Expert Remote System (ERS) and it is working.
I have low ping times, around 20ms. Works great, no problems.
But i want to use CW with a straight key on the E-Coder2. I hear a side-tone, but the SunSDR DX is not transmitting.
I read de manual 'Expert Remote System (ERS) SETUP MANUAL_19-05-2023' carefully and there is at the end a message:
Point 8:
."8. With Ping less than 100ms you should have smooth operation in SSB and digital modes. Transmission in CW mode is not implemented yet!".
My ping times are low, is it not possible to enable CW automatically if the ping times are low in the software?
Regards,
PA3HFN