sq3rx wrote:
I still don't have idea how to configure AGC. Can you provide any screenshots ?
Regarding AGC/output power settings it depends somewhat on your set up, but assuming you are running wsjt and ESDR2.
There are two level controllers, the one on wsjt called "Pwr" and the one in ESDR2 options -> VAC called "TX gain"
1. Start by setting wsjt "Pwr" to mid and "TX gain" to -20dB
2. Set ESDR2 "Drive:" to 0%
3. Right click on signal meter and select "TX" -> "Mic-meter"
4. Press "Tune" on wsjt-x
5. Start increasing "Pwr" and "TX gain" until "Mic-level" is just below zero (lets say -3 to 0) (My settings are full "Pwr" on wsjt and -14dB in VAC, this is a matter of taste I guess)
6. Go back to "power/SWR-meter" on the signal meter as in #3
7. Now you have a good input level and can start increasing "Drive:" to wanted output power.
Dont forget to sett RX-level to approx 50dB in wsjt by adjusting VAC "RX gain"
I hope this helps.
73
/T