Welcome, Guest
Username: Password: Remember me

TOPIC: Enable Transmit Analyzer for Receiver

Enable Transmit Analyzer for Receiver 01 Sep 2020 11:35 #1

  • W2PH
  • W2PH's Avatar
  • OFFLINE
  • Posts: 47
  • Thank you received: 2
It would be really nice to be able to use the transmit Analyzer in the receive mode to allow us to analyze stations on the air to see where their audio spectrum lies. I realize it will take a strong signal to make it usable. Thanks Ed W2PH
The administrator has disabled public write access.

Enable Transmit Analyzer for Receiver 01 Sep 2020 20:15 #2

  • G4ENZ
  • G4ENZ's Avatar
  • OFFLINE
  • Posts: 36
  • Thank you received: 11
SDC Software Defined Connectors has an Audio scope tool that you might find does the job for you.

73 Martin
G4ENZ
The administrator has disabled public write access.

Enable Transmit Analyzer for Receiver 02 Sep 2020 16:55 #3

  • N8SDR
  • N8SDR's Avatar
  • OFFLINE
  • Posts: 624
  • Thank you received: 294
If you expand (you'll most likely need to increase your spectrum display) you can get a really good amount of information on where's ones audio lies and also there Tx bandwidth and IMD products, it takes time to get and comprehend but after sometime you begin to recognize most of what you are asking from looking at the panadater in an expanded view-
73 Rick
Last Edit: 02 Sep 2020 16:56 by N8SDR.
The administrator has disabled public write access.

Enable Transmit Analyzer for Receiver 18 Oct 2020 18:54 #4

  • W2PH
  • W2PH's Avatar
  • OFFLINE
  • Posts: 47
  • Thank you received: 2
Thanks for the above replies, I would prefer it to be able to use the well designed Tx display shown with the drop down arrow next to "PROC" by enabling "Show Analyzer. It has audio frequencies already labeled and would be an excellent way to analyze received signals for audio waveform. Expanding the IF display doesn't provide audio frequency markers.
Thanks
The administrator has disabled public write access.
Time to create page: 0.067 seconds